No.1 Lutai AVE, High-tech Industrial Area, Zibo City,Shandong Province, China
PRODUCTS
Polyurethane Rigid Foam Is a High Polymer Formed By High Pressure Spraying Through Special Equipment Mixed With Isocyanate And Polyether As Main Raw Materials Under The Action Of Foaming Agent, Catalyst, Flame Retardant And Other Additives. There Are Two Kinds Of Polyurethane Foam: Soft Foam And Hard Foam. The Soft Bubble Has An Open Cell Structure And The Hard Bubble Has a Closed Cell Structure.
Polyurethane Foam Is Mainly Used For Thermal Insulation, Refrigeration Equipment And Cold Storage, Thermal Insulation Plate, Wall Insulation, Pipeline Insulation, Heat Insulation Of Storage Tank, Single Component Foam Caulking Material, Etc.
FEATURE
2. Shock-Proof And Pressure-Resistant, No Cracking, No Corruption, No Falling Off After Curing.
3. With Ultra-Low Temperature Heat Conductivity, Heat Insulation.
4. High Efficiency Insulation, Sound Insulation, Waterproof And Moisture-Proof After Curing.
5. The Caulk Can Be Adhered To Concrete, Coating, Wall, Wood And Plastic Surfaces.
TYPE
200 Spray Polyurethane
- 30 Seconds To Reach Final Volume
- Cures In Under 5 Minutes
- Density Of 35 kg/m³
200 Injection Polyurethane
- 60 Seconds To Reach Final Volume
- Cures In Under 8 Minutes
- Density Of 35 kg/m³
600 Spray Polyurethane
- 30 Seconds To Reach Final Volume
- Cures In Under 5 Minutes
- Density Of 35 kg/m³
600 Injection Polyurethane
- 60 Seconds To Reach Final Volume
- Cures In Under 8 Minutes
- Density Of 35 kg/m³
OPERATION
1. For maximum efficiency and optimum foam quality surface temperatures should be between 65 °F (18°C) and 89° F (32° C).The cylinders should be at 75° F to 85° F to get the most yield. During colder months make sure to warm up the cylinders to 75 ° F to 85° F
2. Take out the hose and gun assembly. Attach the hoses to cylinders as you see in the figure with the wrench provided. Attach Blue collared hose to POLYOL and Red collared hose to ISOCYNATE
3. Shake the cylinders for 3 minutes. To shake, roll tanks on their side and rock back and forth.
4. Open the valves. Valves open in the reverse direction.
5. Apply petroleum jelly to inside face of gun and around the edges of the ports.
6. Insert a nozzle (Listen for a “snap” for full insertion) and spray into a waste container until the streams are equal and forms rigid foam structure.
7. If needed, reapply petroleum jelly and insert a new nozzle and continue spraying.
8. If the chemical is not distributed evenly, see the troubleshooting section on the next page
9. Spray at 6-22 inches (15-60cm) from the surface. The polyurethane foam will rise and become tack free in about 60 seconds. Make sure that the cap/nozzle holder is locked before spraying as shown in the figure. If you stop spraying for more than 30 seconds, replace the nozzle with a new one.
APPLICATION
Related products
